T9: Antennas and Feed Lines questions (2026β2030 Technician pool)
All 23 questions from subelement T9, Antennas and Feed Lines, with the correct answer marked. Your exam draws one question from each group below, so you'll see 2 T9 questions. On test day the answer order can be shuffled, so learn the answer, not the letter. Tap "Why" for a plain-English explanation.
T9A (11 questions, 1 on your exam)
- A. An antenna built from square aluminum beams
- B. An omnidirectional antenna invented by Clarence Beam
- C. An antenna that concentrates signals in one direction β
- D. An antenna that focuses the signal into two intense rays
Why, and a memory hook
A beam antenna concentrates signals in one direction.
Memory hook: Beam aims the signal.
- A. Electrically lengthening by inserting inductors in radiating elements β
- B. Inserting a resistor in the radiating portion of the antenna to make it resonant
- C. Installing a spring in the base of a mobile vertical antenna to make it more flexible
- D. Strengthening the radiating elements of a beam antenna to better resist wind damage
Why, and a memory hook
Loading electrically lengthens an antenna by inserting inductors in the radiating elements, which lets a shorter antenna resonate.
Memory hook: Loading coils add electrical length.
- A. By the shape of the driven element
- B. By the orientation of the electric field β
- C. By the orientation of the magnetic field
- D. By the direction of radiation
Why, and a memory hook
Antenna polarization is described by the orientation of its electric field.
Memory hook: Polarization = E-field direction.
- A. It has low efficiency β
- B. It transmits only circularly polarized signals
- C. It is more susceptible to receiver desensitization
- D. It only works on analog signals, not digital ones
Why, and a memory hook
A handheld's short flexible antenna has low efficiency compared to a full-size quarter-wave antenna.
Memory hook: Short rubber duck, low efficiency.
- A. Lengthening it
- B. Inserting coils in series with radiating wires
- C. Shortening it β
- D. Adding capacitive loading to the ends of the radiating wires
Why, and a memory hook
Shortening a dipole raises its resonant frequency, because shorter antennas resonate at higher frequencies.
Memory hook: Shorter, higher.
- A. 5/8 wave vertical
- B. Isotropic
- C. J pole
- D. Yagi β
Why, and a memory hook
A Yagi, a directional beam, offers the greatest gain of the listed antennas.
Memory hook: Yagi is high gain.
- A. Signal strength is reduced due to the shielding effect of the vehicle β
- B. The bandwidth of the antenna will decrease, increasing SWR
- C. The SWR might decrease, decreasing the signal strength
- D. The handheld will overheat due to reflected power in the vehicle
Why, and a memory hook
A vehicle's metal body shields the radio signals, so signal strength is reduced when a handheld is used inside without an external antenna.
Memory hook: Car body is a shield.
- A. It has high gain
- B. It is a resonant half-wave
- C. It is a resonant quarter-wave β
- D. It has low RF radiation exposure
Why, and a memory hook
A quarter wavelength on 2 meters is about 19 inches, so a 19-inch vertical is a resonant quarter-wave.
Memory hook: 2 m quarter wave is 19 inches.
- A. It has more gain β
- B. It radiates at a higher angle
- C. It has lower SWR
- D. It has lower impedance
Why, and a memory hook
A 5/8-wavelength vertical has more gain than a 1/4-wave antenna because it concentrates the signal toward the horizon.
Memory hook: 5/8 beats 1/4 in gain.
- A. Equally in all directions
- B. Off the ends of the antenna
- C. In the direction of the feed line
- D. Broadside to the antenna β
Why, and a memory hook
A half-wave dipole radiates its strongest signal broadside to the antenna, perpendicular to the wire, and little off the ends.
Memory hook: Broadside strong, ends weak.
- A. The additional power that is added to the transmitter power
- B. The additional power that is required in the antenna when transmitting on a higher frequency
- C. The increase in signal strength in a specified direction compared to a reference antenna β
- D. The increase in impedance on receive or transmit compared to a reference antenna
Why, and a memory hook
Antenna gain is the increase in signal strength in a specified direction compared to a reference antenna.
Memory hook: Gain is focus compared to a reference.
T9B (12 questions, 1 on your exam)
- A. PL259
- B. BNC
- C. Type N
- D. All these choices are correct β
Why, and a memory hook
Any outdoor connector, such as PL-259, N or BNC, can let in moisture, so they should all be carefully taped or sealed for weather protection.
Memory hook: Seal every outdoor connector.
- A. 8 ohms
- B. 50 ohms β
- C. 600 ohms
- D. 12 ohms
Why, and a memory hook
Coaxial cable used in amateur radio is most commonly 50 ohms.
Memory hook: Coax: 50 ohms.
- A. It is easy to use and requires few special installation considerations β
- B. It has less loss than any other type of feed line
- C. It can handle more power than any other type of feed line
- D. It is less expensive than any other type of feed line
Why, and a memory hook
Coax is the most common feed line because it is easy to use and requires few special installation considerations.
Memory hook: Coax is easy.
- A. It matches the antenna system impedance to the transceiver's output impedance β
- B. It helps a receiver automatically tune in weak stations
- C. It allows an antenna to be used on both transmit and receive
- D. It automatically selects the proper antenna for the frequency band being used
Why, and a memory hook
An antenna tuner matches the antenna system impedance to the transceiver's output impedance.
Memory hook: Tuner matches impedances.
- A. The characteristic impedance decreases
- B. The loss decreases
- C. The characteristic impedance increases
- D. The loss increases β
Why, and a memory hook
Coax loss increases as signal frequency increases.
Memory hook: Higher frequency, more loss.
- A. PL-259
- B. Type N β
- C. RS-213
- D. DB-25
Why, and a memory hook
Type N connectors are well suited for frequencies above 400 MHz, as they keep their impedance and low loss at UHF and above.
Memory hook: N for UHF and up.
- A. They are preferred for microwave operation
- B. They are watertight
- C. They are commonly used at HF and VHF frequencies β
- D. They are a bayonet-type connector
Why, and a memory hook
PL-259 connectors are commonly used at HF and VHF frequencies, but are not ideal at UHF.
Memory hook: PL-259 for HF and VHF.
- A. Water intrusion into coaxial connectors
- B. High SWR
- C. Multiple connectors in the line
- D. All these choices are correct β
Why, and a memory hook
Coax loses power through the conductor resistance, dielectric losses and mismatch/water, so all the listed items are sources of loss.
Memory hook: Coax loses in many ways.
- A. Local thunderstorm
- B. Loose connection in the antenna or feed line β
- C. Over-modulation
- D. Overload from a strong local station
Why, and a memory hook
Erratic SWR changes are often due to a loose connection in the antenna or feed line.
Memory hook: Wiggly SWR: check connections.
- A. There is no significant difference between the two types
- B. RG-58 cable has two shields
- C. RG-213 cable has less loss at a given frequency β
- D. RG-58 cable can handle higher power levels
Why, and a memory hook
RG-213 is a larger cable with less loss at a given frequency than RG-58.
Memory hook: Big cable, low loss.
- A. 50-ohm flexible coax
- B. Multi-conductor unbalanced cable
- C. Air-insulated hardline β
- D. 75-ohm flexible coax
Why, and a memory hook
Air-insulated hardline has the lowest loss of the listed feed line types.
Memory hook: Hardline loses the least.
- A. A measure of how well a load is matched to a transmission line β
- B. The ratio of amplifier power output to input
- C. The transmitter efficiency ratio
- D. An indication of the quality of your stationβs ground connection
Why, and a memory hook
SWR is a measure of how well a load is matched to a transmission line.
Memory hook: SWR = match quality.
Test yourself on these
Take a free 35-question practice exam drawn one per group, just like the real thing.
Start the free practice testβ T8: Signals and EmissionsAll subelementsT0: Safety β